TIGRESS
From tigwiki
This Wiki site is intended to provide a collaborative authoring environment for documentation on how to use TIGRESS. It is written for the users, by the users. It is a living document. If you would like to contribute, please see the section on Contributing Content.
Contents |
[edit] General
- Getting Access to the wiki, Plone and Elog pages
- Shift Duties - What to do when you are on shift.
-
MIDAS Status Page - See the status of the DAQ system for the experiment
- The E-Log - Go here to add e-log entries
- TIGRESS Plone-CMS Page - Permanent documentation, reports, hardware manuals, etc.
- Contact Information for people associated with TIGRESS (and 8pi and GPS)
- LN2 system
- High Voltage Status Page
- Detector Testing Status
- Clover Detector Status
- Experimental Data Storage and Backup
[edit] Configuration
- Clover Coordinate Table in lab frame
- Coordinate systems and numbering schemes overview
- Current TIGRESS Configuration
- TIGRESS Suppression Shields
[edit] Experiment Setup
- BAMBINO Target Ladder Source Holder
- Front Suppression Shield Fine Alignment
- High Voltage for HPGe and Suppressors
- Suppression Shield Gain Matching
- TIGRESS CLOVER Configurations - High Efficiency and Optimized Peak-to-Total
- Vacuum Procedures
- Swan Preamplifier Mapping
[edit] DAQ Systems
- Epics Front-End -- client for transferring data between EPICS and MIDAS
- Gain Matching
- ODB Parameters
- Scalers
- Spectrum Analyzers
- State-of-Health
- Starting and Stopping the MIDAS Clients -- use this to start the acquisition computers from scratch or to get some hints on how to fix back-end DAQ systems
- TIGRESS Event Bank Format
- Striptool
- Trigger Parameters
- Utilities
- Proposed Event Builder System
- Multiple Front Ends
- Recent Changes ...
[edit] Detector Testing
- Clover Detector Powering Procedure
- Clover Initial Testing
- Suppression Shield Testing
- Current Detector Configuration in TIGRESS Lab Rm156
- Scanning Table Setup
- Instructions on Single Scan Setup.
- Clover Coincidence Scan
- Test Setup Vacuum Chamber
[edit] Infrastructure
[edit] Miscellany
- Caen HV
- FPGA Programming -- experts only!
- Computers and Accounts -- list of computers, what they are used for, logins, password hints, etc.
- Using TIGRESS Detectors with Ortec 660 HV
- Jeff Dech's Code Locations -- Describes where to get and how to use code Jeff Dech (summer student) contributed in Summer 2009.
- TIGRESS Wish List -- Put your list of issues that need resolution here.
- Setting Up a New PC -- Instructions on how to set up a new PC with SLinux and properly configure it for use on the TIGRESS cluster.

